There will be times when you need to create static routes for specific subnets within your network. The ADC provides you with the ability to do this using the Static Routes module.
Adding a Static Route
Click the Add Route button
Fill in the field using the details in the table below as guidance.
Click the Update button when done.
Field
Description
Destination
Enter the destination network address in decimal dotted notation. Example 123.123.123.5
Gateway
Enter the gateway IPv4 address in decimal dotted notation. Example 10.4.8.1
Mask
Enter the destination subnet mask in decimal dotted notation. Example 255.255.255.0
Adapter
Enter the adapter that the gateway can be reached on. Example eth1.
Active
A green tick box will indicate that the gateway can be reached. A red cross will indicate that the gateway cannot be reached on that interface. Please make sure you have set up an interface and IP address on the same network as the gateway
Static Route Details
This section will provide information about all the routes configured on the ADC.
